Chlorinated solvents source identification by nonlinear optimization method.

In this work, chloride ions were used as conservative tracers and supplemented with conservative amounts of chloroethenes (PCE, TCE, Cis-DCE, 1,1-DCE), chloroethanes (1,1,1-TCA, 1,1-DCA), and the carbon isotope ratios of certain compounds, the most representative on the sites studied, which is a novelty compared to the optimization methods developed in the scientific literature so far. A location of the potential missing sources is then proposed in view of the balances of the calculated mixing fractions. A test of the influence of measurement errors on the results shows that the uncertainties in the calculation of the mixture fractions are less than 11%, indicating that the source identification method developed is a robust tool for identifying sources of chlorinated solvents in groundwater.

Using 1,1,1-Trichloroethane degradation data to understand NAPL dissolution and solute transport at real sites.

Analytical and numerical models describing the evolution of contaminant concentrations in the plume associated with the dissolution of NAPL source and degradation processes were presented in the literature. At real sites and particularly in complex aquifers like chalk, it is difficult to understand how the sources of contaminants evolve with time. 1,1,1-Trichloroethane (1,1,1-TCA) is one of the few compounds with a well-known hydrolysis constant, that can help to improve knowledge of the contaminant sources and transport rates of dissolved contaminants in groundwater by dating the spill. In this work, different scenarios that could explain the evolution of the concentrations of 1,1,1-TCA and its degradation product 1,1-Dichloroethene (1,1-DCE) at a real contaminated site were investigated by analytical and numerical modelling. The results show that (1) the peaks of concentration time series do not correspond to a single contamination event even in the case of a complex medium, (2) the multiphasic behavior of the concentration time series is dictated by the dissolution in a heterogeneous medium, and (3) the persistence of the concentrations can arise from a small residual organic phase or transport in dual domain medium.

Field demonstration of foam injection to confine a chlorinated solvent source zone.

A novel approach using foam to manage hazardous waste was successfully demonstrated under active site conditions. The purpose of the foam was to divert groundwater flow, that would normally enter the source zone area, to reduce dissolved contaminant release to the aquifer. During the demonstration, foam was pre generated and directly injected surrounding the chlorinated solvent source zone. Despite the constraints related to the industrial activities and non-optimal position of the injection points, the applicability and effectiveness of the approach have been highlighted using multiple metrics. A combination of measurements and modelling allowed definition of the foam extent surrounding each injection point, and this appears to be the critical metric to define the success of the foam injection approach. Information on the transport of chlorinated solvents in groundwater showed a decrease of contaminant flux by a factor of 4.4 downstream of the confined area. The effective permeability reduction was maintained over a period of three months. The successful containment provides evidence for consideration of the use of foam to improve traditional flushing techniques, by increasing the targeting of contaminants by remedial agents.